First, the difference between siphon toilets and straight flush toilets
1. Flushing principle
The principle of siphon flushing is the use of siphon principle, that is, the drainage pipe will form a certain water level difference after being filled with water, and the sewage pipe can produce suction to discharge the dirt when the toilet is flushed.
The direct flush toilet is relatively simple and rough, and the air compression is formed by the impulse of the water flow, and the dirt is discharged.
2, flushing capacity
From the flushing principle, it is not difficult to see that the flushing power of the direct flush toilet is more concentrated, the flushing time is shorter, but the flushing efficiency is relatively high, it is easier to wash away larger dirt, and it is not easy to form a blockage.
In contrast, the siphon toilet is easier to wash away the dirt attached to the surface of the toilet, which is more conducive to the cleaning of the toilet itself, and the flushing effect is relatively thorough.
3. Deodorant effect
Due to the direct flush toilet, the residual stains on the surface of the toilet are not washed thoroughly, and it is easy to have residue, so the odor prevention effect will not be very good, especially the toilet without water seal, often there will be odor.
The siphon toilet comes with a water seal effect, and the flushing is relatively thorough, so the odor prevention effect will be better.
In summary, the two kinds of toilets have their own advantages, and the scope of application is different. For example, the siphon toilet is more suitable for the bathroom area is relatively large, and the family population is more than the price. The direct flush toilet is more suitable for small bathroom, toilet usage is not high in the family.
Second, how to prevent the toilet odor
Unscrew the back of the toilet, clean the glass glue on the edge of the toilet, move the toilet away from the original position, and wet the downpipe with clean water.
The seal ring at the bottom of the toilet is also fully soaked, which can effectively reduce the resistance during installation, and the center of the toilet is aligned with the center of the sewer pipe and pressed into the pipe bend. Find out the ground water pipe and the center of the toilet, make a mark, put the flange directly opposite the water pipe mouth, place the toilet in the same position, and then seal it with glass glue. This can effectively make the drainage and sewage under the ground, while the joint area is also sealed, and the odor is difficult to penetrate.
It can be seen that the difference between the siphon toilet and the direct flush toilet is the deodorization effect, the flushing principle, the flushing ability, etc., in addition, the toilet must pay attention to deodorization during use to avoid the odor affecting the daily use experience.
