Taking a bath is a very enjoyable thing, and it is necessary to have a good bathtub at home. Below, the editor will introduce a very good bathtub brand – American Standard bathtub.
1. How about the American Standard bathtub?
1. Comfort: The American Standard bathtub adopts a brand-new nozzle design, with a unique hydraulic whirlpool and unique vibration and beating function, a spacious enough interior space and a backrest design that conforms to the human body shape, pushing the bathtub comfort to another peak;
2. Health: American Standard bathtub has ozone generator, disinfection system, phototherapy lighting and other equipment, 100% safety testing, to provide a healthier bathing environment;
3. Practicality: sturdy and durable, long-lasting as new, good thermal insulation, American Standard pays more attention to the convenience of the bathtub when designing;
4. Appearance: The appearance of the American Standard bathtub is perfect, the design style is fashionable and concise, and it presents a warm and natural style. The touch-sensitive control panel with LED backlight in the design can also show the noble temperament.
2. American Standard bathtub installation
1. Inspection: After the American Standard bathtub is transported indoors, first use pliers to open the steel hoop of the horizontal beam, then remove the cover over the bathtub, and check the items in the bathtub in detail against the order number (to prevent missing accessories or confusing items during assembly. ), and finally check whether the cast iron cylinder block with ceramic surface is in good condition.
2. Assembly: There will be three black gaskets in the box for the water removal accessories in the American Standard bathtub, generally two large and one small, and each has a direction, so pay attention to distinguish it, otherwise it will cause water leakage due to improper installation .
Therefore, before assembling, check for water leakage. First, lay the bathtub on its side, and bend the steel pipe drain pipe according to the shape of the bathtub to facilitate fixing.
Then unscrew the water hose, put a bucket of water in the bathtub, plug the outlet of the water hose with your hand, and check whether there is water leakage in each interface and hose. This can avoid water leakage after installation, which is difficult to check. Case.
3. Pedestal: Note that there is no need to stick wall and floor tiles in the place where the bathtub can be blocked.
When building the platform, first determine the position where the four cast iron contacts on the cylinder body contact the ground according to the size of the bathtub as shown in the figure and the size measured on site, and then build two red bricks at the height of each contact position, and use a level ruler. Horizontal and vertical diagonal leveling.
4. Placement: When moving the bathtub, lift and place it gently to ensure the safety of all parts. First, fine-tune it in place, insert the sewer hose into the drainage pipe that has been stopped slightly above the ground, and use a spirit level to level the cylinder body horizontally and vertically diagonally. , four-legged fine-tuning.
Then use red bricks to build non-load-bearing wall skirts in the direction where it is necessary to make skirts. Pay attention to leave an inspection port in the middle of the overall height of the bathtub at the upper and lower water positions, with a size of at least 200cmm*300cm, otherwise it will not have the maintenance function.
5. Tiling: The next day after the wall skirt is built is the best time for tiling. After the bathtub is installed, it depends on the specifications of the skirt tiles. The wall skirt is about 500cm high and should be seamed with the bathroom wall and floor tiles as much as possible. If there are narrow strips, consider using the waistline as decoration.
The above is the introduction of the American Standard bathtub and how to install the American Standard bathtub. The American Standard bathtub is a brand recognized by the market and loved by consumers. You definitely deserve it!
