The decoration of bathroom room is never simple. In addition to storage and expansion, in fact, it also has extremely high requirements on hard installation. Otherwise, the light is gorgeous and beautiful in appearance but uncomfortable everywhere, which will also affect the living experience of the next decades.
Therefore, if you want your bathroom room to be beautiful and practical, you should at least be prepared from the following points.
1. Circuit
The wire joint of the bathroom room must be hung tin and wrapped with waterproof tape and insulation tape, to ensure the safety of electricity, must be set on the flame retardant tube all switches and sockets must also have moisture-proof box, and the location should depend on the convenience and reasonable use of electrical appliances, in order to reduce unnecessary trouble.
Step 2: Water
If it is the supply and drainage line of the second-hand bathroom room, it is best not to do too much. If the change is because of the different models of the washing machine leading to the change of the water position and other problems, it also depends on the specific situation, it is best not to change.
3. Sanitary ware
Before decoration, it is necessary to remember that the distance between the water hole and the sanitary ware is selected according to the size. Bathtub, shower room, toilet, wash basin and other sanitary ware are not found to be of inappropriate size when they are bought back. When installing the toilet bowl, it is necessary to seal it first, and then fix it with expansion screws or glass glue, so that it can be repaired when blocking in the future.
Step 4 Ventilate
The bathroom room must have the exhaust fan, and the exhaust fan had better have the reverse gate to prevent turbidity gas backflow, etc.
5. Ceiling
The water vapor in the bathroom room is heavy and easy to lead to rust and mildew, so we should choose those with waterproof, anti-corrosion, anti-rust characteristics of the material to do the ceiling.
Step 6: The ground
Before the bathroom is paved with floor tiles, it is necessary to do a good job of waterproof engineering. After paving the floor tiles, it is necessary to ensure that the brick surface has a 1° water slope toward the floor drain. In addition, it is necessary to do a closed water experiment for more than 24 hours. The floor tile should also be welded and aligned with the wall tile to ensure the overall beauty of the bathroom room.
Step 7: Wall
The wall tile of the bathroom room should also pay attention to moistureproof, waterproof and as far as possible to ensure smooth, if the cut of the outlet tile of the water supply pipeline should be small and appropriate, convenient for the flange cover on the water supply device to cover the notch, which requires slightly higher technological level of the decoration workers.
8. Doors and Windows
When viewing the house, it is best to choose the bathroom room with Windows. If there is no window, we should think about how to make up for it through decoration: the door should be slightly lower than the outdoor side of the bathroom to prevent the water spilling out of the bathroom room; The gap between the bathroom door and the ground should be slightly larger, conducive to ventilation and breathable; If the bathroom uses sliding door, but also between the sliding door and the floor tile to do a layer of waterproof treatment.
9. Greening
Do not think that the bathroom room can not have green, add some shade resistant, wet like green plants in the bathroom room can add how much anger for the bathroom room, can also become the most bright decoration in the bathroom room.
The advice provided by the decoration master is very practical. In hard installation, the bathroom can also be beautiful!
