Everyone in many moments will accidentally drop the phone into the water, such as the toilet, the sink or the moment the cup is knocked over and poured on the water with the meal. If this moment the phone screen has not been able to light up, do not experiment with the boot. So what should we do with it? And listen to the career knowledge in detail.
After the phone into the water, trust a lot of resourceful users may be a clever move to remember their homes still have a hair dryer, take out as a dryer to make. Don’t laugh, ROM base around me also really have partners to do so. The truth is that this will not only save your phone, but the phone in the intensive care unit was sent directly to the morgue.
In fact, not only the hairdryer does not work, the heater also does not work. In reply to the previous question, we have to understand why the phone into the water will be bad. The internal circumference of the cell phone integrated circuits are exceptionally delicate, in case of water easy to short circuit in case of fire easy to burn bad.
A little more bad luck, the liquid drilled into the interior of the phone is not clean, weak acids and strong alkalis a toss, there is still a possibility of erosion components, resulting in the danger of not being able to repair. Remember the three words, can not reverse! Once a cell phone killer asked me very seriously, the same phone into the water after the phone to get dry, why prefer not to use the hair dryer?
Now most of the phones are wimpy smart phones, no longer who can smash walnuts in the Nokia of yesteryear. The hot air of the hair dryer is very easy to make accessories preheat melting, mechanical internal water met with hot air into water vapor, it is possible to seep into the screen, will make the phone damp, damage to electronic components, resulting in the second time can not reverse the danger.
In the case of power on fall into the water
This situation as usual does not require dismantling disposal. Solution facilities are as follows.
1, if the screen is still bright, must be disconnected as soon as possible, the ability to withhold the battery machine should be immediately withheld from the battery, the battery quickly removed. Similar to the iPhone can not snap the battery of the phone should also be forced to shut down.
2, if the phone automatically shut down, the screen is no longer bright, you can never experiment with power on, a power on, then the current may break through the motherboard, the phone will also be mostly scrapped.
3, dry with force, but do not throw off the machinery, the idea is to throw out the water inside the screen. If there are water droplets left on the screen, there will be traces after drying.
4, placed under a table lamp, spotlights and other slight heat source to let the moisture gradually dissipate. This journey takes more than six hours.
5, many people like to accept the hair dryer to blow, but the hair dryer is not very good, easy to lead to the original water into the place where the water. Don’t use hot air to blow, because it will be dangerous to the phone’s screen and even burn the phone’s internal parts.
Of course, if there is no condition, you can only do so, but only cool air blowing dry, and must ensure that the phone is as dry as possible before blowing. After these three steps of disposal, the power supply can be connected to the basic normal thing.
In the case of power failure dropped into the clear water
This situation can basically be identified as no mechanical damage. However, it is possible that the inside of the phone may be the same as the water, rare is the layer of LCD screen under the touch screen. Solution facilities are as follows.
1 dry with force, but do not throw off the machinery.
2 If there is no trace on the LCD screen, according to the first point of Article 3 disposal.
3 If the screen has a residual device and very serious, do not dispose of the first point of Article 3, because the disposal of the electronic circuit can be normal things, but the screen may be quite ugly. Can be sent to the nearest maintenance department disposal or start to disassemble the mechanical finishing by themselves.
Falling into the erosive liquid or sticky liquid or other unclean liquid
This situation is the poorest. However, the timing of the mechanical recovery after proper disposal is also great. Solution facilities are as follows.
1. as soon as possible power off.
2. If it is dropped into the erosive liquid (such as seawater, urine), immediately flush the machinery with anhydrous alcohol, if there is no alcohol, you can use water instead, but be very careful to prevent further deterioration of the situation.
3. Dismantle the machinery as soon as possible, but the moment of dismantling the machine should come gradually.
4. Use alcohol or professional washing machine water to wash clean.
5. will be disassembled department put together, if not put together, you disassembled the whole pile of equipment to the maintenance point, so that the maintenance point for you to organize again as well as put together.
