The toilet is often used in our life, and the key role is the water tank of the toilet bowl, the water tank of the toilet bowl has a lot of accessories, then the water tank accessories installation should be how to do? Today Xiaobian will introduce you to the installation of the toilet tank accessories.
Many people are familiar with the toilet bowl this kind of kitchen and bathroom products, but for the toilet bowl accessories installation but understand little, in fact, the toilet tank accessories installation is not complicated, according to step by step, I believe many people can learn.
One: Installation of the main parts of the toilet bowl
1. Determine the installation position and drill holes on the ground. After aligning the sewage drain port on the ground with the sewage drain port at the bottom of the toilet bowl, mark the position of the fixed hole in the bottom corner of the toilet bowl based on the outer dimensions of the toilet bowl base, and drill the hole using a hammer drill. The hole depth is about 5 cm.
2. Install the toilet base. Hammer the steel expansion bolt into the ground borehole, insert the bottom corner of the toilet into the expansion bolt, and tighten the nut to put the toilet in place. The toilet drain outlet and the preset drain pipe on the ground should be closely connected and sealed.
3, Install the water tank (connected toilet does not need this step) according to the installation height of the water tank and the hole position of the rear wall of the water tank, drill holes in the corresponding fixed position on the wall and knock in the steel expansion bolt, then put the water tank in place, insert the expansion bolt into the hole of the rear wall, add the 3mm thick nylon washer, then put the nut and tighten it.
4. Install the connection pipe between the water tank and the toilet base (with copper pipe or plastic pipe, etc.), and the connection pipe between the water inlet pipe and the bottom of the water tank (with stainless steel bellows, etc.). Angle valve (water inlet control valve) should be installed at the connection of water inlet pipe.
Two: toilet bowl other accessories
1. Install the floating ball and other accessories in the water tank.
2. After opening the water inlet valve, adjust the floating height of the float ball according to the water inlet height required in the tank, and adjust the tightness of the control screw according to the water spraying size of the water valve.
3. After the water tank is filled with water, check the sewage capacity of the toilet bowl and whether there is leakage in the connection of each pipe.
4. Seal the gap between the toilet base and the ground with putty or silicone. Cement slurry or cement mortar shall not be used as sealing material.
5. Install toilet seat and toilet seat cover.
Toilet bowl selection points
Water storage: Should choose the toilet with moderate water storage, water storage too high will splash butt, water storage too low easy to run smell.
Glaze: The glaze of a good quality toilet should be smooth and smooth without foaming, color saturation. After testing the outer surface glaze, should also go to touch the toilet sewer, if rough, later easy to cause the hanging.
Read the above introduction of the toilet tank fittings installation, I believe the toilet tank fittings installation also have some understanding. With reference to the above analysis, it may be possible to install the toilet tank fittings reasonably. Hope to help you solve the problem of toilet tank fittings installation.
