First, what are the installation steps of the squat toilet
1, before installing the squat toilet, you should first determine the specific installation position and actual size of the squat toilet. Secondly, a pipe for discharging sewage should be reserved at the appropriate position from the wall according to the sewage outlet of the squat toilet purchased by you, and you must remember to keep an appropriate distance between the pipe entrance and the ground.
2. Next, the installation position should be dug into a pit, and the depth of the pit must be higher than the height of the squat toilet, so that it will be more convenient to install the squat toilet in the later period.
3. Then the connecting glue plug should be deep into the water inlet hole of the squat toilet, and it should be stuck tightly. It is also necessary to apply some glass glue to seal the outer edge of the water inlet hole in contact with the squat toilet, and then insert the water inlet pipe into the connecting rubber plug, so that the water inlet pipe can be well sealed together with the connecting rubber plug, so as to avoid leaking when using the toilet in the later period.
4. Then apply some glass glue at the edge of the outlet of the squat toilet, and then put the squat toilet into the entrance of the sewage pipe for screwing, and then use the coke residue and other fillers to fill the squat toilet, so that the squat toilet can be set up more level, and there will be no tilt and instability.
Second, what are the precautions for the installation of squat toilets
1, the installation of the squat toilet should be based on the sewage outlet of the installed product, reserve the sewer pipe in the appropriate position from the wall, and determine the distance between the sewer pipe entrance and the ground plane.
2, after the installation of the squat toilet to check the joint without water leakage, fill the toilet around the filler, while the contact surface of the ceramic and cement mortar filled with more than 1cm of asphalt or felt and other elastic materials. The squat toilet is fixed in the horizontal plane with cement mortar, stable and firm, and then the toilet floor tile is laid on the cement surface. Test flush, if no abnormal can be used.
3, after the installation, to open the water inlet system, check the joint for water leakage, if there is water leakage, you should check the joint until the problem is solved.
The squat toilet is to determine the specific installation position and actual size of the squat toilet before installation. After the installation of the squat toilet, check whether there is leakage in the joints everywhere, and timely find and modify it.
