What is the installation size of the shower head? The relevant standards formulated by the industry are often based on the experience of past users, and the average value is taken. Therefore, it has a certain universal significance and is also in line with the habits of ordinary users. This article intends to briefly introduce the basic requirements for the installation size of shower flowers.
The installation size of the shower head mainly involves the installation positions of the following four components.
1、混水阀距地面的高度
为淋浴预留的内丝弯头是为下一步安装混水阀做准备。其高度一般控制在90-110cm之间。中间可以根据主人的要求或者夫妻俩的平均身高来确定。 110cm，否则会导致带升降杆的花洒安装不上，不要低于90cm，而且每次打开阀门都要弯腰不太好。
2、两个内线孔之间的距离
Experienced plumbers know that the standard for the reserved spacing of the inner wire elbow of the shower is that the error of 15cm for concealed installation should not exceed 5mm, and that for exposed installation is 10cm. If it is too wide or too narrow, it will not fit. Don’t rely on the adjustment of the alignment wire. The adjustment range of the alignment wire is very limited.
3、墙砖粘贴后，与墙面保持一个平面
The thickness of the wall tiles should be considered when reserving the thread head. It is best to make it 15mm higher than the rough wall. If it is not good, it will not be able to install the shower. However, it does not dare to be too high above the wall. If it is too high, the decorative cover will not be able to cover the thread head and the adjustment screw, and it will be ugly.
4. Fixing of inner wire elbow
The fixing of the inner wire elbow is very important. If it is not fixed, the size cannot be positioned. It is very likely that the mixing valve cannot be installed after decoration, because it will lose its position when touched.
Knowing the installation size of the shower head is very beneficial for us to check and accept the installation project. After all, it is easier to find problems and deal with them in time than to remedy them afterwards.
