1. 浴缸堵塞了怎么办
1、浴缸排水管堵塞，可先关闭排水阀，然后在浴缸内放入适量的自来水；将橡胶吸污器（疏通马桶用）置于排水阀上；一边打开排水阀，一边将吸污器堵住面盆或浴缸的溢水孔；然后快速上下吸污，将污物或毛发吸出，并及时清理。堵塞严重者，可反复多次，直至疏通。
2. A blockage that occurs near the bathtub drain can be addressed in several places—the overflow, the bathtub drain, or the drum trap. We start with the tub drain. If you can’t unclog the blockage here, try the overflow again, then try the drum trap.
3、如果浴缸的排水管堵塞，用橡胶吸具无法疏通，则先用排水弯头螺旋钻疏通浴缸口处的排水管。
4. The method of using the auger for draining the elbow is as follows: Remove the pop-up plug or filter screen of the blocked drain pipe, and insert the steel cable of the auger into the mouth of the drain pipe. To feed the soft cable into the drain, turn the handle of the auger; to increase the length of usable cable, loosen and then tighten the thumbscrew on the handle. If the cable hits something, turn the auger handle while pumping it back and forth. Then continue to turn the handle while slowly pulling the auger out.
二、浴缸是否漏水
1、塑料下水管时间久了老化，出现孔洞，导致漏水，更换下水管就行。
2、排水口与浴缸连接处有缝隙，造成漏水，解决方法是用干毛巾擦干排水口，再用玻璃胶密封。
3. The sewer pipe is not fully inserted into the drain pipe from the floor under the bathtub, resulting in water leakage. The solution is to lift the bathtub and insert the sewer pipe.
4. It may be that the joint between the drain and the bathtub is glued, causing leakage. Check carefully, and re-glue it with waterproof all-purpose glue for a week, and then use it after the cracks are dry and sealed. There is a gap at the junction of the drain and the bathtub, causing water leakage. The solution is to dry the drain with a dry towel and seal it with glass glue.
5、可能是清理堵塞时不小心弄断了下水管，仔细检查更换下水管。下水管老旧老化，天气突然变冷，自然结冰开裂，造成渗水，仔细检查更换下水管。地面防水层老化，造成渗水，查明后重新做防水部分。下水管从浴缸下方地板插入排水管时没有完全插入，导致漏水，解决方法是将浴缸抬起，插入下水管。
