Tip 1: Fill the tub with warm water 2 inches above the highest nozzle, or leave the water in the tub after use. Add two tablespoons of low-foam: powdered automatic dish soap and a small amount of household bleach to the water. Run the tuina for 5 to 10 minutes, then close, drain, and flush the outside of the tub with water. The bathtub is durable in a hot and humid state, it will breed many bacteria, and sometimes after cleaning, the outside looks clean, and there are still many bacteria in reality. China cleaning network recommends regular use of boiling water to wipe the outside of the bathtub, do not use disinfection water, because disinfection water is not sure to kill mold and fungi.
Tip 2: Real time repair wounds bathtub installation do not move privately, need to move the position, must contact professional staff. Do not hit the outside with hard objects, causing bruises or scratches. If the acrylic bathtub needs to repair the bleached or scratched section, it can be wiped vigorously with a clean rag mixed with a colorless automatic sanding solution, and then coated with a layer of colorless precious wax. Do not wax the foot area to prevent slipping.
Tip 3: Gentle disposal of outside stains You can use a discarded soft toothbrush dipped in bleach powder water to scrub the outside, which can remove stains and eliminate mold. In the case of difficult stains, you can also use half a lemon dipped in salt to wipe, you can also use a soft toothbrush coated with whitening toothpaste scrub, turpentine is also very good at this time. For limescale, usually the product used to clean the toilet is very good, if you don’t like the pungent taste can also use lemon and white vinegar this natural way. Do not use detergent with fading effect, rare is the home bathtub with color. For mold and fungi causing bacteria, rinse with bleach water and peroxide water and dry immediately.
Tip 4: Dispose of pipe blockage at any time and disinfect the pipe on time once or twice a week to remove the taste and prevent the growth of bacteria. You can use a special product to clean the sewer, pour it into the sewer, wash it after 5 minutes, pay attention not to use it in metal pipes. If the bathtub is blocked, the water valve can be closed first, and then put an appropriate amount of tap water in the bathtub; Place the rubber aspirator (for unclogging the toilet) on the drain valve; Close the overflow hole in the basin or bathtub while opening the drain valve; Then it quickly draws up and down, sucking out dirt or hair and sorting it out in real time. In the case of serious blockage control, it can be repeated several times until it is cleared and cleaned.
Washing points to note:
Prevent the use of dark cleaners, which can easily cause pigment to seep into the cylinder surface. The water halter should be tightened to avoid frequent dripping and causing water in the bathtub. Do not leave metal items in the bathtub, or the outside of the bathtub will be rusty and dirty.
