首页资讯

Waterproof construction techniques This section describes the precautions for waterproof construction

Waterproof construction techniques This section describes the precautions for waterproof construction

2023-06-26 09:06:13

With the progress of society and the improvement of people’s living standards, our demand for life has become more and more. Therefore, in our home decoration waterproof construction has become a key step, more and more families will also choose to paint waterproof materials, below we will introduce the waterproof construction precautions for you.

防水施工技巧

First, the thickness of the waterproof layer should be enough.

2. Choose brand products with high visibility, good reputation, high degree of anti-counterfeiting and international quality system certification when purchasing.

Third, the waterproof part should be comprehensive: the ground and all the walls of the basement should be waterproof and moisture-proof.

Fourth, the construction process should be careful: the joint between the wall and the ground, the Angle of Yin and Yang, the surrounding of the water pipe, the floor drain and the sanitary ware, and the digging trench of the laying of hot and cold pipes are the key waterproof parts.

5. Closed water test after completion: After completion of construction, seal the door and water outlet, store water indoors for 24 hours, and check whether there are leakage points.

6, if found leakage should be remedied in time.

Waterproof construction precautions

First, the ceiling should choose waterproof, anti-corrosion, anti-rust materials.

Second, waterway transformation: it is best not to make too much change to the water supply and drainage lines.

Third, the ground: be sure to do a good job of waterproof before paving tiles; To ensure that the brick surface has a drainage slope (generally about 1), the slope towards the floor drain; The closed water test must be done for at least 24 hours after laying. When paving the floor tile, pay attention to the joint and alignment with the wall tile to ensure the sense of integrity.

Fourth, the wall: the wall tiles should also be waterproof, and the tiles should be smooth and aligned with the floor tiles; When encountering the outlet of the water supply pipeline, the cut of the tile should be small to ensure a perfect appearance.

5. Door: The door boundary should be slightly higher than the inside of the bathroom; The gap between the ground and the ground should be large to facilitate the return air; If it is a sliding door, a layer of waterproof should be made between the door and the floor tile.

Six, circuit laying: wire joints must be wrapped with waterproof tape and insulation tape; The wire body must be covered with flame retardant tube; All switches and sockets must have moisture-proof boxes.

Seven, sanitary ware installation: it is best to measure the distance of the water hole before decoration, and choose the sanitary ware according to the size; The toilet should be sealed with mud first, and then fixed with expansion screws or glass glue to facilitate repair when blocking occurs.

8. Ventilation: the exhaust fan must be equipped with a retrograde gate to prevent the backflow of dirty air.

Nine, greening: choose shade-resistant, moisture-loving pot, can add vitality.

The above is the relevant introduction we have brought to you today, I believe that friends have a certain understanding, I hope this article can help you. You can also log in to the Fuwu home network to view and subscribe more related content and information.