First, what should I do if the faucet leaks
In normal life, sometimes you will find that the faucet will still drip after tightening, and it will drip continuously from the faucet exit or junction, which not only causes a lot of waste, but also sometimes its sound will cause certain troubles. In fact, the structure of the faucet is very simple, the maintenance of water leakage can be completely repaired by yourself, in general, the problem of water leakage can be solved as long as the shaft gasket or triangle gasket and other sealing parts inside the faucet are replaced. But you have to turn off the faucet before you start the renovation.
Regarding the water leakage repair at the faucet joint, the reason for the water leakage is nothing more than the damage of the water sealing tape of the faucet part (fixing screw). Therefore, as long as the use of the plate pliers to remove the faucet, in the fixed screw on the place to reroll the new sealing tape, the following steps for maintenance: first, the faucet is fastened, with the plate pliers to turn the faucet in a counterclockwise way to remove. Second, turn the thread hole outward, and wind printing tape on the clock roll 5-6 times in the thread part.
See whether the faucet has been adjusted to fasten the water bolt plate clamp in the direction of the clock, and finally after the installation is completed, open the main switch to try to confirm whether there will be water leakage.
Second, even if the faucet is fastened, what is the reason for the water leakage
1. The reason for the water outlet leakage: it is due to the wear of the shaft gasket in the faucet. Use pliers to loosen the gland bolt and remove it, take out the shaft gasket with the clamp, and replace it with a new shaft gasket.
2. The reason for the water leakage in the lower gap of the faucet bolt: it is caused by the wear of the triangle gasket in the gland. You can loosen the screw to remove the bolt head, then loosen the gland to remove, and then take out the inner triangle gasket of the gland and replace it with a new one.
3. Water leakage at the nozzle joint: basically, the cap nut is loose, at which time you can re-fasten the cap nut or replace it with a new U-shaped gasket.
If the faucet is found to have less water, it may be a leakage situation, because the water stop disk of the single gun faucet is stuck in the sand, this phenomenon is still to find a professional maintenance engineer to disassemble the faucet to clean up, but if the rubber pad is damaged, it must be replaced. In general, the correct use of the faucet refers to not rotating the faucet too tightly, so that the faucet rubber pad can maintain a life of 7 or 8 years, but the hot water part of the faucet is easy to reduce its life due to thermal expansion and contraction, so it is usually recommended that the rubber pad on both sides can be replaced regularly at the same time.
以上就是关于水龙头的简单介绍，希望对大家有所帮助。
